Replying to CNC Mill Machinist / Programmer
Unregistered User Info
Enter your Name
Code Buttons
 Guided Mode
 Normal Mode 		  Close all Tags

Open Tags:   
Enter your Post
Clickable Smilies
smilie smilie smilie
smilie smilie smilie
smilie smilie smilie
smilie smilie smilie
smilie smilie smilie
     
Show All

Check Post Length · BB Code Help
Post Options  Enable emoticons?
 Enable signature?
Original Post to Quote
You may edit the post you are quoting here
Post Icons
Cancel Post
Send Post
                                
                                
  [ Use None ]
User Verification To keep away spam, please complete the following:
 



Last 10 Posts [ In reverse order ]
Jeff Burns Posted on Feb 20 2009, 12:30 PM
  Opening for full time CNC mill programmer / set-up and operate. Must be familiar with Hass controls, and have CAD/CAM & manual programming experience. Day shift, pay dependent upon experience.

contact:
tel# 858-483-2893
fax# 858-483-0737




Location: San Diego
Compensation: Dependent upon experience
Principals only. Recruiters, please don't contact this job poster.
Phone calls about this job are ok.
Please do not contact job poster about other services, products or commercial interests.
Review the complete topic (launches new window)

Hosted for free by InvisionFree* (Terms of Use: Updated 2/10/2010) | Powered by Invision Power Board v1.3 Final © 2003 IPS, Inc.
Page creation time: 0.1427 seconds | Archive